Clipsal C-Bus2 Specifications download pdf (Page 63)

2C. Advanced Programming

Function Action

Idle No action

Store 1 This stores the current level in internal the Recall 1 memory location (Blocks

tab). When the Recall 1 function is used, the group level reverts to this state.

The level is stored in non-volatile memory. No transmission is made over the

C-Bus

Network.

Downcycle The output level is ramped down to minimum. If the output is already at

minimum, it ramps up to maximum.The Downcycle function should be used

in conjunction with the End Ramp function to ensure that ramping ends

at the desired level. The direction of output ramping changes with each

successive Downcycle / End Ramp operation. This allows a single button

to act as an up/down light dimmer. The Off Key function can be used to

terminate ramping if required. A RAMP TO LEVEL message is transmitted

over the C-Bus Network.

Memory Toggle If the output is on, the Memory Toggle function stores the current level in

the Recall 2 memory location (Blocks tab) and switches the output off. If the

output is off, the function sets the output to the last level stored in the Recall

2 memory location (the previous brightness level). An OFF or RAMP TO

LEVEL message is transmitted over the C-Bus Network.

Down Key This function is similar to Downcycle except that it can only ramp the output

level downwards. The output will be ramped to the minimum level unless

either the End Ramp or Off Key function terminates the process early. The

ramp rate for the Down Key function is set by the 'Ramp 1' parameter

(Global tab). The Down Key function has no effect if the current output is in

the off state. A RAMP TO LEVEL message is transmitted over the C-Bus

Network.

Up Key The output level increases to the maximum level, unless either the End

Ramp or Off Key function ends the process early. The ramp rate for the Up

Key function is set by the 'Ramp 1' parameter (Global tab). If the current

level is already at a maximum, no action will occur. A RAMP TO LEVEL

message is transmitted over the C-Bus Network.

Recall 1 The output level is set to the level stored in the Recall 1 memory location

(Blocks tab). A RAMP TO LEVEL message is transmitted over the C-Bus

Network.

Recall 2 The output level is set to the level stored in the Recall 2 memory location

(Blocks tab). A RAMP TO LEVEL message is transmitted over the C-Bus

Network.

Retrigger Timer The retrigger timer command starts the internal timer only if the output is

currently on (at any level). If the output is already on, the timer is restarted.

A RAMP TO LEVEL message is transmitted over the C-Bus Network.

Start The internal timer is started without affecting the output level (if the timer

value is greater than zero).An ON message may be transmitted over the

C-Bus Network.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 119 120

Comments to this Manuals

No comments

Clipsal C-Bus2 Specifications Page 63

Comments to this Manuals

Related products and manuals for Touch screen monitors Clipsal C-Bus2